Fuel Injector Cleaner Car Won't Start
Fuel Injector Cleaner Car Won't Start. Plug one of the spark plugs back into its spark plug boot, and ground the body of the plug by placing. , 99 cents store raylube injection cleaner.engine stopped running in traffic.
Dude that sucks good luck. Do check the ecm once the fuel pump is changed. This can be because of faulty little rubber o rings where they connect into the injectors.
Generally, You Put The Fuel System Cleaner In When The Tank Is Empty, Then You Fill It Up To Mix The Product In With The Gasoline.
Postby crimson240sx » sat nov 26, 2005 9:02 pm. Your needle valve or float could be stuck. This is a fast and simple way to clean your injectors at home without any complicated equipment.spray nine:
Up To $8 Cash Back 27 Years Of Experience.
If you don't have a fuel pressure gage, slowly remove the fitting that you would normally connect the gage to and put a piece of tubing on it and put the other end in a gas can. I suspect your problem is unrelated to the fuel injector cleaner that you added. Same think happened to me.
Dude That Sucks Good Luck.
Stp is even worse than i thought if they're directing you to put it in a full tank of gas. For fuel injected and carbureted cars first, let's look at the obvious: Turned off the car and realized my door was to.
Pulled The Ignition Coil And Stuck A Spark Plug In Each Boot One At A Time And Had A Jumper Cable To Ground The Plug Threads.
Turn the ignition on and off without starting it to prim the pump do this a 3 or 4 times. Just to be sure we have pressure. And if the car is still hot it will take longer to get it started.
Disconnect The Starter And Turn The Engine Over.
Reinstall the fuel rail, making sure to align properly. Or if there is no spark on a cylinder or 2 you'll also have unburnt fuel. The map sensor was bad and would not allow the computer to send the injector pulse.
Post a Comment for "Fuel Injector Cleaner Car Won't Start"